"The opinions posted here do not represent those of any company, organization, or group and are those only of the author of the respective post." - From Rontini |
Lockwire |
Post Reply |
Author | |
Sewer Pipe Snipe
BBS Supporter Joined: 04 Jan 2016 Location: Albany, GA Status: Offline Points: 5723 |
Post Options
Thanks(0)
Posted: 09 Dec 2018 at 6:29am |
That is correct for the Stainless .032 wire normally used. The new wire was a lot thicker and it was 4-6 per inch. Yes, I left out the thickness just in case.
|
|
Walt,
Had I done everything right throughout my life, the World wouldn't have noticed. |
|
fortyrod
Rickover Joined: 05 Jan 2016 Location: Mannsville NY Status: Offline Points: 1955 |
Post Options
Thanks(0)
|
I'm not a nuc, but, on an LM2500 using .032 lockwire it was 6-8 twists/inch minimum
|
|
Everything is relative
|
|
Sewer Pipe Snipe
BBS Supporter Joined: 04 Jan 2016 Location: Albany, GA Status: Offline Points: 5723 |
Post Options
Thanks(0)
|
When some genius, in the early seventies, went to the heavier lock-wire on the reactor compartment door. How many pair of standard lock-wire pliers did you break before you violated the written procedure and went to vise grips? Anyone got any idea why the change? I know they came out with a heavier set of lock-wire pliers shortly after getting the feedback. As an Ollie, "What was the twist rate of a properly applied lock-wire?
|
|
Walt,
Had I done everything right throughout my life, the World wouldn't have noticed. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |