"The opinions posted here do not represent those of any company, organization, or group and are those only of the author of the respective post." - From Rontini |
Need Help With Question |
Post Reply | Page <12 |
Author | |
Dr. Stan
Rickover Joined: 04 Jan 2016 Location: Sevierville, TN Status: Offline Points: 7455 |
Post Options
Thanks(0)
|
Qualified as RO on 610 in 1963 but I can't recall any Main Steam valve switches or indicator lights on the RPCP. There were switches/lights for MC valves, etc., but MS valves I don't recall. Doesn't mean they weren't there but . . .?
|
|
It has been my experience that folks who have no vices have very few virtues.~Abe Lincoln
SS-393, SSBN-610(B), SSBN-624(G), SSN-591 USSVI Life Member; Holland Club; Plank Owner, Smoky Mtn. Base |
|
Dantini
Rickover Joined: 15 Jan 2016 Location: Washington Status: Offline Points: 568 |
Post Options
Thanks(0)
|
Dr. Stan let me test your memory: As an RO on the 610 when you had a scram, didn't you first shift the MCPs from fast to slow (if they were running in fast) and then shut MS 1 & 2? Who else besides the RO would have shut those valves? That was before Thresher went down. After that, MS 1 & 2 were not shut as a matter of fact depending upon the cause of the scram, and a possible rapid restart of the Reactor was commenced with an emergency high power startup rate allowed.
Sewer pipe - that would be the 637 not the 627 class
|
|
Sewer Pipe Snipe
BBS Supporter Joined: 04 Jan 2016 Location: Albany, GA Status: Offline Points: 5723 |
Post Options
Thanks(0)
|
You mean I was right and only thought I was wrong? This getting old just isn't that much fun. Forgetting stuff from 45 years ago shows my mind is slipping.
|
|
Walt,
Had I done everything right throughout my life, the World wouldn't have noticed. |
|
Dr. Stan
Rickover Joined: 04 Jan 2016 Location: Sevierville, TN Status: Offline Points: 7455 |
Post Options
Thanks(0)
|
Well, Dan, I have not seen or even thought much about an RPCP in 49 years so my memory has faded somewhat. Further, I was sitting at the RPCP at S1W when I heard the news about the Thresher, so when I qualified on the Edison toward the end of 1963 the procedures may have been changed. However, the MS switches would likely not have been relocated; so, apparently, I have just forgotten about them. However, I do remember some switches like the MCP, MCV and, in particular, the In-Hold-Out switch. So, even though my memory is like Swiss cheese (i.e., full of holes) some traces do remain. But, sadly, I failed your MS switch test. |
|
It has been my experience that folks who have no vices have very few virtues.~Abe Lincoln
SS-393, SSBN-610(B), SSBN-624(G), SSN-591 USSVI Life Member; Holland Club; Plank Owner, Smoky Mtn. Base |
|
SaltiDawg
Rickover Joined: 03 Jan 2016 Location: Rockville, MD Status: Offline Points: 2865 |
Post Options
Thanks(0)
|
I also failed the location part. !@#$%&
All of us have referred to the SPGP, RPCP, and EPCP. Actually it was the SPGB, was it not? |
|
Dantini
Rickover Joined: 15 Jan 2016 Location: Washington Status: Offline Points: 568 |
Post Options
Thanks(0)
|
No problem Dr. Stan,. My memory is fading fast too.
Saltidawg; the panels are the EPCP - Electric Plant Control Panel. RPCP - Reactor Plant Control Panel, and the SPCP- Steam Plant Control Panel. You may be confusing the SPCP with SGWLCP (Squiggle) the Steam Generator Water Level Control Panel which was located in AMR #2 upper level.
|
|
SaltiDawg
Rickover Joined: 03 Jan 2016 Location: Rockville, MD Status: Offline Points: 2865 |
Post Options
Thanks(0)
|
No confusion - I may well be mistaken, however.
|
|
SaltiDawg
Rickover Joined: 03 Jan 2016 Location: Rockville, MD Status: Offline Points: 2865 |
Post Options
Thanks(0)
|
Did some more homework, and I can not find a single reference to SPGB anywhere. However, on my first Nuke, the CO insisted that EOOWs had to qualify fully at all subordinate watch stations. When I had my EOOW Final Board I was not left with a bunch of oolies to look up.
Lt. Bell asked me to name the three aft-facing "panels" in Maneuvering. I gave the stock answer, he signed me off, and told me to check on the nameplates. I did. Had Capt. White later asked me that question I would have answered to include SPGB. (He asked me no questions, but rather told me he was proud of me and gave me a talk on responsibility.) I'm quite sure he gave me the same talk when I qualified OOD and also in Submarines. Edited by SaltiDawg - 24 Jul 2017 at 9:41am |
|
Post Reply | Page <12 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |